全站搜索

 
 
The use of stainless steel float switches re-Chung
Author::    Author::2013-01-12 14:37:23    Writing:【big】【in】【in
Abstract:Abstract: The use of the hammer device: (stainless steel float switch) float level switch cable penetration from the center of the concave circular hole of the hammer at, gently push the hammer, so embedded in the round hole aboveplastic ring off the cable head thrust. (If necessary, can also be used a screwdriver to remove the plastic ring), then fall off the plastic ring on the cable you want a fixed set level position, new style hammer directly with cable penetration pull out to the required you can adjust the position. 2 by gently pushing the hammer pulled cable, plastic ring until the hammer Center withhold, hammer lightly pressed in the plastic ring that will not slide off the plastic ring any damage or loss, available with a diameter bare copper wire buckle cables instead. (Under normal circumstances: hammer the attached accessories). Note: the cable line directly pulled the control box, try to avoid using the middle connector. If it is a last resort and joints, absolutely not cable connector immersed in liquid.
 
 
脚注信息
Copyright(C)2009-2013 Shanghai Meikun Electronic Technology Co.,Ltd